125 kHz RFID module "PICO-Module"
This is an ultra compact writing and reading module for 125 kHz RFID tag (Hitag1/S (2048 bit)). All of the required installation elements for the "easy-to-use" operation are situated on a circuit board measuring 19 x 33 mm. The implementing is carried out through wiring it with a regular spindle antennae and the 5 V DC operating voltage. The bi-directional communication is effected through a TTL compatible serial interface. Corresponding level converters are available for hooking the PICO-Module up to a PC. Outlets for control LEDs and a programming interface for subsequent firmware updates are integrated on the circuit board. The controlling is carried out through a few, simply structured commands. You do not have to take care of the communication between RFID tag and the RW-device as it is performed automatically by the PICO-Module.
 |
If desired the data are encoded with a 32Bit-code. Thus, unauthorised reading or cloning of the RFID tag card is impossible. The PICO-Module has a 14-pole 2-row connector and can be installed horizontally as well as vertically. The inexpensive price and the compact size enable employment in numerous applications.
Our engineers are glad to assist you in realizing any customer projects. PICO-module is a high-performance and inexpensive alternative to adjust and adapt electronic applications to function with RFID technology.
|
Technical data:
Module size:
Interface:
Supply voltage:
Power consumption:
Power output for relais:
Read/write timing: |
19 x 33 in mm
14 pin connector, 2 rows, 2.54 mm grid
5 Volt DC (TTL)
typical 50 mA
max. 250 mW
typical below 200 ms
|
 |
Downloads:
| Show 1 to 3 (of in total 3 products) |
Sites: 1 |
|
|
