Hook-up MIRRORMAID Sensor

EXT - external hook-up 6-pole pole-connector (2-row) with the following configuration

GND = mass (ground)
OUT = inverted open-collector output against GND
LED = LED switch hook-up (low active)
OUT = sensor output signal (GND or VCC)
VLED = LED supply voltage (+12 V)
VCC = sensor supply voltage (+2,5 up to +5 V DC)

SNS - sensor hook-up
Solder connection for sensors

JP1 - jumper sensitivity
jumper adjusting the sensors' sensitivity optional sensitivities: high - middle - low

JP2 - jumper switching performance
jumper adjusting the switching performance optional switching performance: operation via pushbutton or switching

If desired, it is of course also possible to order material needed for constructing the sensors such as self-adhesive copper foliage and sensor wire. Our engineers and technicians are more than happy to inform and assist you in implementing your projects. Our services range from supporting the designing of products and projects to constructing complete samples and exhibits.

We are more than happy to assist you in integrating the MIRRORMAID sensor electronics into your circuits. This way you save expenses on material and equipment.